Incline Dumbbell Flyes
- Chest
- Shoulders
EquipmentDumbbell

New to this
Your first incline dumbbell flyes
Three things to know before your first set of the incline dumbbell flyes.
What weight should I start with on the incline dumbbell flyes?
Start with 10 or 15 lb dumbbells for 3 sets of 12. Flyes put a lot of stretch on the chest with your arms out wide, so the weight stays far below your press.
Set the bench to about 30 degrees. Press the dumbbells up, then open your arms wide in a slight bend and bring them back together over your chest.
Add 5 lb per hand when 15 reps feel controlled.
What usually goes wrong on the incline dumbbell flyes?
You bend your elbows more on the way down. That turns it into a press. Keep the same slight bend.
You lower too far. Stop when your elbows are level with the bench.
You clang the dumbbells. Stop just short of touching.
If you'd rather use a cable
The incline cable fly and the cable crossover keep tension on your chest the whole rep.
Updated
How to do it
Hold a dumbbell on each hand and lie on an incline bench that is set to an incline angle of no more than 30 degrees.
Extend your arms above you with a slight bend at the elbows.
Now rotate the wrists so that the palms of your hands are facing you.
Tip: The pinky fingers should be next to each other. This will be your starting position.
As you breathe in, start to slowly lower the arms to the side while keeping the arms extended and while rotating the wrists until the palms of the hand are facing each other.
Tip: At the end of the movement the arms will be by your side with the palms facing the ceiling.
As you exhale start to bring the dumbbells back up to the starting position by reversing the motion and rotating the hands so that the pinky fingers are next to each other again.
Tip: Keep in mind that the movement will only happen at the shoulder joint and at the wrist. There is no motion that happens at the elbow joint.
Repeat for the recommended amount of repetitions.









