Standing Leg Curl

  • Hamstrings

EquipmentMachine

Standing Leg Curl demonstration
Front
Back
Main muscleAlso working

New to this

Your first standing leg curl

Three things to know before your first set of the standing leg curl.

What weight should I start with on the standing leg curl?

Start around 20 to 30 lb on the stack for 3 sets of 10 per leg. One leg at a time is a lot weaker than both, so the number will look low.

Set the pad just above your heel and line your knee up with the machine's pivot. Lean slightly forward onto the support.

Move the pin down a plate when 15 slow reps per leg feel easy.

What usually goes wrong on the standing leg curl?

Your hip swings back as you curl. Keep your hips against the pad and move only at the knee.

You kick the weight up. Curl in a second and lower in two.

You stop halfway. Curl until your heel is close to your glutes, then pause.

If the standing curl is taken

The lying and seated leg curls train the same muscle with both legs. A Romanian deadlift works your hamstrings with a hinge instead.

Updated

How to do it

  1. Adjust the machine lever to fit your height and lie with your torso bent at the waist facing forward around 30-45 degrees (since an angled position is more favorable for hamstrings recruitment) with the pad of the lever on the back of your right leg (just a few inches under the calves) and the front of the right leg on top of the machine pad.

  2. Keeping the torso bent forward, ensure your leg is fully stretched and grab the side handles of the machine. Position your toes straight. This will be your starting position.

  3. As you exhale, curl your right leg up as far as possible without lifting the upper leg from the pad. Once you hit the fully contracted position, hold it for a second.

  4. As you inhale, bring the legs back to the initial position. Repeat for the recommended amount of repetitions.

  5. Perform the same exercise now for the left leg.