Bent Over Two-Dumbbell Row

  • Upper Back
  • Biceps
  • Lats
  • Shoulders

EquipmentDumbbell

Bent Over Two-Dumbbell Row demonstration
Front
Back
Main muscleAlso working

New to this

Your first bent over two-dumbbell row

Three things to know before your first set of the bent over two-dumbbell row.

What weight should I start with on the bent over two-dumbbell row?

A pair of 20 or 25 lb dumbbells for 3 sets of 10. Judge the weight by whether you can pause for a beat with the dumbbells at your ribs.

Hinge forward until your torso is about 45 degrees from the floor, knees soft, back flat. Let the dumbbells hang straight down from your shoulders before each rep.

When you can do 12 reps with that pause at the top, go up 5 lb per hand.

What usually goes wrong on the bent over two-dumbbell row?

You stand up a little more each rep. By the end of the set you're shrugging instead of rowing. Hold the same angle from the first rep to the last, and go lighter if you can't.

You pull toward your chest. Drive your elbows back toward your hips so the dumbbells finish beside your lower ribs.

Your lower back rounds. Push your hips further back and keep your chest up. If your lower back tires before your upper back does, switch to a row with one hand on a bench.

If your lower back gets tired first

A one-arm dumbbell row with a hand on a bench supports your torso. A seated cable row or the row machine trains the same muscles with nothing to balance.

Updated

How to do it

  1. With a dumbbell in each hand (palms facing your torso), bend your knees slightly and bring your torso forward by bending at the waist; as you bend make sure to keep your back straight until it is almost parallel to the floor.

    Tip: Make sure that you keep the head up. The weights should hang directly in front of you as your arms hang perpendicular to the floor and your torso. This is your starting position.

  2. While keeping the torso stationary, lift the dumbbells to your side (as you breathe out), keeping the elbows close to the body (do not exert any force with the forearm other than holding the weights). On the top contracted position, squeeze the back muscles and hold for a second.

  3. Slowly lower the weight again to the starting position as you inhale.

  4. Repeat for the recommended amount of repetitions.