Standing Cable Wood Chop
- Abs
- Shoulders
EquipmentCable

New to this
Your first standing cable wood chop
Three things to know before your first set of the standing cable wood chop.
What weight should I start with on the standing cable wood chop?
Start around 15 to 25 lb on the stack for 3 sets of 10 per side. The point is turning through your torso with control.
Set the pulley high, stand side-on and grab the handle with both hands. Pull it diagonally down across your body to the opposite hip, pivoting your back foot.
Move the pin down a plate when 12 per side feel smooth.
What usually goes wrong on the standing cable wood chop?
You pull with your arms. Keep them fairly straight and turn through your torso.
Your back foot stays planted and your knee twists. Let your back foot pivot as you turn.
You let the weight pull you back fast. Return over two seconds with your abs braced.
If the cable is taken
The Russian twist trains the same rotation on the floor. The Pallof press works the same muscles by resisting the turn.
Updated
How to do it
Connect a standard handle to a tower, and move the cable to the highest pulley position.
With your side to the cable, grab the handle with one hand and step away from the tower. You should be approximately arm's length away from the pulley, with the tension of the weight on the cable. Your outstretched arm should be aligned with the cable.
With your feet positioned shoulder width apart, reach upward with your other hand and grab the handle with both hands. Your arms should still be fully extended.
In one motion, pull the handle down and across your body to your front knee while rotating your torso.
Keep your back and arms straight and core tight while you pivot your back foot and bend your knees to get a full range of motion.
Maintain your stance and straight arms. Return to the neutral position in a slow and controlled manner.
Repeat to failure.
Then, reposition and repeat the same series of movements on the opposite side.









